tangency

英

美

网络  切线连续; 接触; 相切; 切向参考; 切矢连续

复数：tangencies　

英英释义

noun

• (electronics) a junction where things (as two electrical conductors) touch or are in physical contact
  1. they forget to solder the contacts
  Synonym:contact
• the state of being tangent

双语例句

• Author discusses the smart application of orthogonal transformation in multivariate function integrals, solving some difficult problems of multiple function integrals with the new point of tangency finding between linear algebra and calculus.
  把正交变换巧妙的应用到多元函数的积分中去，解决了多元函数积分中的一些应用难题，找到了线性代数与微积分的新切点。
• The essence of arc joining is making the tangency of the arc and line or the arc and arc. The programmed Drawing method of arc joining based on AutoCAD secondary-development is studied in this article. The Visual LISP drawing program of arc joining is merited.
  圆弧连接的本质就是使圆弧与直线或圆弧与圆弧相切，在此研究了基于AutoCAD二次开发的圆弧连接程序化绘制方法，用VISUALLISP语言编程建立了圆弧连接通用绘图程序。
• The asset pricing model and this is critical assumes everyone is rational and holds the tangency portfolio.
  资本资产定价模型是非常重要的模型-，假设每人是理性的，并持有切线资产组合。
• Emergency Solution to the Equipment Failure of Subnet Access Node in Tangency SDH Loop
  相切组网SDH子网接入点失效的应急方案
• Tangency is controlled by the first two control points from a surface boundary, assuming that these points lie in one line.
  相切是由曲面边界的最初两个控制点控制的（假设这些点在一条线上）。
• Then everyone should be holding the tangency portfolio.
  所有人都应该持有切线投资组合。
• The optimal allocation of the certainty and severity of penalty under the cost restrain is the point of tangency of the curve of equal deterrence and the curve of equal cost of deterrence.
  成本约束下的刑罚确定性与严厉性的最优配置是等威慑水平曲线与等威慑支出曲线的切点。
• Concepts about bridge node and loop tangency are proposed. The principle of the loop shrinkage of the signal flow graphs is deduced from the point of view of the equivalence of node split.
  提出了桥结点、环路相切概念，从结点分裂的等价观点出发，导出了信号流图中环路收缩的原理。
• Taking the reform in curriculum system, content of courses and teaching method as our point of tangency;
  以课程体系、教学内容和教学方法的改革为切入点，大力加强传统专业的更新改造；
• With the Lagrange multiplier method, the minimum distance of the center of a circle and a quadric surface was provided and the tangency condition of curve and surface was given.
  利用拉格朗日乘子法求解二次曲线和二次曲面之间的最小距离，给出了曲线与曲面相切的条件。